Central Roof Repair · Code Notes
A flat roof is a figure of speech. In the Kentucky Residential Code every low-slope roof covering in Section R905 carries a minimum design slope — one-fourth unit vertical in 12 units horizontal for almost all of them — which means standing water on a dead-level deck is a slope question before it is a patching question.
What minimum slope does the code require?
One-fourth in 12, which the code states as a 2 percent slope, for drainage. That same figure repeats across the low-slope systems, with one exception.
| Roof covering | Section | Minimum design slope |
|---|---|---|
| Built-up roof | R905.9.1 | 1/4 : 12 (2 percent) |
| Coal-tar built-up roof | R905.9.1 | 1/8 : 12 (1 percent) |
| Modified bitumen membrane | R905.11.1 | 1/4 : 12 (2 percent) |
| Thermoset single-ply, such as EPDM | R905.12.1 | 1/4 : 12 (2 percent) |
| Thermoplastic single-ply, such as TPO or PVC | R905.13.1 | 1/4 : 12 (2 percent) |
| Sprayed polyurethane foam | R905.14.1 | 1/4 : 12 (2 percent) |
| Liquid-applied roofing | R905.15.1 | 1/4 : 12 (2 percent) |
| Asphalt shingles | R905.2.2 | 2 : 12, with double underlayment required from 2 : 12 up to 4 : 12 |
The code document itself is a public PDF: the Kentucky Residential Code, Third Edition, published by the Kentucky Department of Housing, Buildings and Construction. Coal-tar built-up is the single low-slope covering the code lets go below a quarter inch per foot, and it is the one you are least likely to find on a Central Kentucky house.
Coal tar is the only low-slope covering the code allows at one-eighth in 12. Everything else owes you a quarter.
Why ponding is a design question
Because the slope is required by design, not by whatever the deck settled into. If a low-slope roof holds water after a storm, the useful question is whether it was ever built to drain, and a reroof is the moment that gets decided.
Three things we look at on a low-slope house roof in Lexington, Richmond or Nicholasville, offered as general trade practice: where the water actually stands once the roof dries around it, whether the drains or scuppers sit at the low point or merely near it, and whether the existing covering is a system the code permits at the slope that is physically there. A membrane installed on a deck with no fall will shed the first inch of rain and keep the rest. Tapered insulation is how that gets corrected on a reroof, and it is a line item worth seeing on a quote rather than discovering afterward.
Residential code or building code?
It depends on the building, not the roof. Section R905 is in the Kentucky Residential Code, which covers one- and two-family dwellings and townhouses. A low-slope roof on a commercial building is administered under the Kentucky Building Code instead, and the two documents do not carry identical text.
We have written that split out separately: Kentucky Residential Code versus Building Code on a flat roof, and which code applies to flat roof repair in Lexington, KY under 815 KAR 7:120. For everything else, start at roof repair in Lexington, KY.
Questions homeowners ask
Is a flat roof actually flat under the Kentucky code?
No. Every low-slope covering in Section R905 carries a minimum design slope of one-fourth unit vertical in 12 horizontal, a 2 percent slope, except coal-tar built-up at one-eighth.
What is the minimum slope for a TPO or PVC roof?
One-fourth in 12, a 2 percent design slope. R905.13.1 sets that figure for thermoplastic single-ply membrane roofs, and R905.12.1 sets the same figure for thermoset single-ply.
Does this apply to a commercial building?
Not directly. Section R905 sits in the Kentucky Residential Code, which governs one- and two-family dwellings and townhouses. Commercial low-slope work is administered under the Kentucky Building Code.
Last updated November 13, 2026.
Code citations are given so you can check them. The authority having jurisdiction for your address makes the final call on which code edition and which sections apply to your project.

Leave a Reply